Item description

Autopoles are an extremely useful device for wedging between two walls, or between the floor and ceiling, in areas where it's inconvenient or not possible to put regular lighting stands. It uses a single-action cantilever locking system that exerts the correct amount of pressure to ensure a secure fit, wedging the protective rubber ends in place. The lever incorporates a safety lock. It's a really useful device for rigging lightweight lighting fixtures, minicams, or backgrounds in inconvenient places.

These are the 032B models that goes from 2.1m to 3.7m.

The diameter of the tubes are 45.4mm, and the weight is 2.1kg each.

There isn't an advertised payload, but it important to use common sense to ensure it is not being overloaded to the point where it could slip, bend, or crack.

Similarly, please do not over-tighten any clamps you may attach to it, to prevent the tube from being deformed.

Need just one? Check out my other listing here: https://www.cinekit.co/en/listings/1598-1x-manfrotto-autopole-2-dot-1-3-dot-7m

I also have 0.7m extensions available incase you need to make it a bit longer. Click here for one: https://www.cinekit.co/en/listings/1600-1x-manfrotto-autopole-extension-0-dot-7m
or here for two: https://www.cinekit.co/en/listings/1601-2x-manfrotto-autopole-extensions-0-dot-7m

Please be advised, that the longer you make it, the more likely it is to sag and slip, so I would only advise this for lighter payloads.